Technical ceramics and medical technology look like a good fit on paper: ceramics are chemically resistant, wear-resistant, sterilisable and largely inert in tissue. Accordingly they have been used there for decades – in joint components, dental restorations and instruments.
This article sets out where additive manufacturing is of interest in this field and where the limit lies. That limit first, because it determines everything else: we build manufacturing equipment and do contract manufacturing; we are not a manufacturer of medical devices. Parts used in or on the human body require approval that attaches to the product – not to the printing process and not to us.
Why ceramics are of interest here at all
- Largely biologically inert. Oxide ceramics such as alumina and zirconia are chemically very stable.
- Wear-resistant. In sliding pairs, ceramics last longer than many alternatives and generate less debris.
- Sterilisable. Ceramics tolerate the usual procedures in principle; with zirconia, steam sterilisation has to be assessed separately because of ageing under heat and moisture.
- Behaviour in imaging. Depending on the material, ceramics are either less conspicuous than metal on an X-ray or deliberately visible – a point that belongs in the design.
Which of the two oxide materials fits is decided by the load, as it is everywhere: zirconia is tougher and more resistant to fracture, alumina is harder and cheaper. The differences are set out in a separate article.
Dental work: the most concrete case
Among the medical applications, dental work is the one that looks closest to us – for a reason that lies not in the ceramics but in regulation: for individual materials in widespread use today, a regulatory restriction is under discussion. Anyone working with them now will need alternatives in the medium term.
Zirconia is established in dental technology, and the geometries are small, individual and in quantities of one – a profile that makes a comparison with milling from a blank worthwhile. Printing near net shape instead of grinding from solid saves material and machine time, and all the more so the more complex the shape.
Another material that can be of interest in this setting is hydroxyapatite – mineralogically close to bone and therefore a subject in its own right in bone-replacement research. For us this is a question still to be clarified, not an offer.
The hurdle: approval
This is where engineering ends and regulation begins. A part used inside the body is a medical device. Requirements attach to that which have little to do with the printing process:
- Product approval with clinical evaluation, depending on the risk class.
- A quality management system at the manufacturer of the medical device.
- Biocompatibility evidence for the specific material in the specific application – not for the class of material in general.
- Traceability and process validation across the entire manufacturing chain.
- Unchanged availability of the approved material over the life of the product.
This hurdle is high, and it is deliberately high. For a company that supplies equipment and contract manufacturing it means: we can contribute material, geometry and process. The manufacturer of the medical device is responsible for approval.
Where the route is open today
The realistic entry point is therefore not the implant:
- Research and development on materials and geometries, before a product route is fixed.
- Functional samples and prototypes, to check a shape before it goes into qualified production.
- Laboratory and test rigs, fixtures and tooling with no patient contact.
- In-house production at the medical device manufacturer. Anyone who is responsible for the conformity assessment themselves can bring a machine into their own quality system – that is the route by which ceramic printing actually arrives in this field.
If you work in this field
Tell us early whether your part is destined for the body or not. That single piece of information decides the entire route from there – the choice of material, the documentation, and what we can commit to as against what you have to take responsibility for as the manufacturer.
On the materials side the usual applies: binding figures are on the datasheet for the particular compound.