Sintering ceramics: what actually happens in the furnace

The step that turns a fragile blank into a part – and that decides whether the geometry is right in the end.

28 October 20266 min ReadCeramics
Sintered ceramic part from pellet-based 3D printing

Anyone having a ceramic part printed for the first time ends up holding something smaller than the file it came from. That is not a defect; it is the nature of the process. In ceramic 3D printing a blank of ceramic powder in a polymer matrix is produced first. Only sintering turns it into ceramic – and the part shrinks as it happens.

What sintering actually means

Sintering means heating a powder body far enough for its particles to bond without the material melting. The grains grow together at their points of contact, the voids between them close and the microstructure densifies. What was a loosely connected heap of powder becomes a solid body.

That is exactly why the part shrinks. The space previously taken up by air between the grains disappears. The volume falls, the density rises. With our materials we reach 98 to 99 per cent of theoretical density – ceramic that is dense for practical purposes.

The route there: debind first, then sinter

Before sintering, the polymer matrix has to come out of the part. This step is called debinding and runs in house with us, supported technically by ifw Jena, the Günter Köhler Institute for Joining Technology and Materials Testing.

After debinding the part is extremely delicate: the powder is held together only by its own packing, and the binder that stabilised it until now is gone. In this state a part survives little more than careful repositioning. Only the furnace gives it its strength.

The furnace schedule – how fast it heats, how long it holds, how it cools – depends on the material. Alumina behaves differently from zirconia. There is therefore no universal temperature table here, but one programme per compound. The equipment for this comes from Nabertherm; we also sell it as a dealer.

Why shrinkage is a design matter

That a part shrinks could simply be allowed for – if the shrinkage were the same everywhere. It only is if the part has the same density and the same amount of material everywhere.

From that follows the most important rule for ceramic parts: even wall thicknesses. If the wall thickness jumps from three to twelve millimetres, the thick section shrinks differently from the thin one. The result is distortion or a crack – visible only after the furnace, once all the work has already gone in.

Two further points from practice:

  • Minimum wall thickness 0.8 millimetres. Below that, even the blank becomes too fragile to survive debinding and transport.
  • Solid up to roughly 15 millimetres. Thicker sections are feasible, but then with a low infill rather than fully solid. That keeps the distribution of material more even and lowers the risk in the furnace.

What the fracture surface reveals

Whether a sintering run has succeeded is not always visible from the outside. A look at the fracture surface of a test part shows more: an evenly fine, closed microstructure indicates full densification, while visible pores or a coarse-grained area point to a furnace schedule that ran too fast or too hot.

What you need to know about it

Three things matter for your design: even wall thicknesses, at least 0.8 millimetres, and a willingness to treat the first part as a learning step. Everything else – furnace programme, hold times, cooling ramps – is our job.

What the process chain from printed blank to finished part looks like in detail is covered in the article on green part, brown part and sintered part. If you have a specific part in mind, send us the geometry – we will tell you what is realistic before you invest the time.