Lattice structures: lightweight design that only works additively

Material only where it is needed – and compliance where it is wanted. What lattice structures deliver and where their limits are.

24 October 20265 min ReadDesign
Lattice structure inside an additively manufactured part

A part rarely has to withstand the same load everywhere. Even so it is usually equally solid everywhere – because conventional processes allow nothing else. A milled piece is made from solid stock, an injection-moulded one from whatever the tool dictates. Additive manufacturing removes that constraint.

What a lattice structure is

Instead of solid material, a regular or deliberately varying framework fills the volume. In extrusion printing it is created as an infill pattern: inside the part, the head does not travel in solid passes but in a pattern with a defined infill density.

That is not a by-product but a design tool. Through pattern and infill density you control weight, stiffness and compliance – within the same part, at no extra cost.

Three things lattice structures deliver

Saving weight. The obvious case. Less material means less mass, less print time and lower cost – see cost factors in 3D printing.

Placing stiffness. Higher infill where the load is, lower where it is not. The part becomes stiff where it has to be stiff, and light where it is allowed to be.

Creating compliance. This is where it gets interesting. A lattice structure made from a hard material can behave softly if pattern and density allow it. The compliance then comes from the geometry, not from the material.

Soft zones without changing material

In orthopaedic technology that is exactly the practical benefit: an insole that supports under the heel and yields in the forefoot can be made as one part. No assembly, no bonded joint that could fail. What that looks like in a continuous process chain is shown in the article on additive manufacturing in orthopaedic technology.

It goes further still if the material is varied as well – through a blowing agent dosed in during printing, for instance. The compliance then comes from geometry and material. See blending compounds and additives live.

Where ceramics have their own rules

With ceramic parts, lattice structures are not a design option but often a necessity: sections above roughly 15 millimetres of wall thickness only make sense with a low infill, because otherwise the distribution of material becomes too uneven and the part distorts in the furnace. There is more on this under green part, brown part, sintered part.

Limits

A lattice structure is only as good as its connection to the outer skin. And it cannot be inspected afterwards: what happens inside a part is not visible from outside. Where demonstrated strength matters, you need test parts – or you give up the last few per cent of weight saving.